Peugeot 3008 2009-2016 - screen and fascia kit
The Peugeot 3008 2009-2016 put its radio deep in the console and its display near the driver's knee. The 9430/2430 lifts a 9-inch or 10.1-inch touch panel above that console on a fascia cut for the plastic already in your car.
The 9430/2430 is built around one car: the Peugeot 3008 2009-2016. Not the 5008, and not the second-generation car from 2016 on. Two consoles turn up under that single model name. One fascia here carries three round openings in a row; the other carries two round openings, a wider centre opening and two small slots above them. Which one is yours? The panel in your car decides, not the year in the advert.
| Model | Vehicle | Model years |
|---|---|---|
| 9430 / 2430 | Peugeot 3008 | 2009-2016 |
If your car's a 5008 from those years, photograph your console and let us look first. I'd rather lose the order than post a fascia that sits proud of the dash. Same if an aftermarket radio was fitted before you: send a picture, because a Peugeot 3008 2012 Factory Radio Replacement only goes smoothly when the last owner left the loom alone.
I keep hearing the same line from 3008 owners: the car swallows a family and a dog, and the dash feels five years older than the rest. Fair. The factory readout is small, orange and set low, so maps end up on a phone in a vent clip, and that clip won't stay put past August, and what changes with this kit isn't only screen size but where you look while driving.
A small console display, radio and trip data only, and a phone doing the navigation from a cradle.
A 9-inch or 10.1-inch panel standing above the console at eye level, with the original heater panel sitting undisturbed in the fascia below. That's the practical definition of a Peugeot 3008 2009-2016 CarPlay Screen: the dials stay where your hand already goes.
Three routes exist for a car this age. Keep the factory unit. Buy a universal double-DIN plate and shave plastic all weekend. Or take a factory fit Peugeot 3008 2009-2016 Car Multimedia Player from the people who cut the fascia, which is the route I'd fit on my own car.
| What you are comparing | Keep the factory unit | A universal kit | 9430 / 2430 |
|---|---|---|---|
| Display | Small console readout, no touch | Size varies by seller | 9-inch or 10.1-inch touch panel |
| Dash trim | Original, untouched | Flat plate, visible gaps | Fascia panel cut for the 3008 |
| Heater panel | Stays as fitted | Often relocated | Reuses the original trim |
| Phone link | Bluetooth audio only | Sometimes listed | CarPlay on the touch panel |
| Version check | Not applicable | You guess from a listing | Checked against your photo |
Compare the shape of the openings in your console before you compare prices.
Moulded for the 3008 console, with the openings for your heater controls cut where the factory put them. No spacers, no gap at the edges.
Maps and calls run on the touch panel instead of a phone in a vent. A Peugeot 3008 2009-2016 GPS Navigation System is what owners notice first.
The panel stands above the console at eye level, so your gear lever and heater dials keep the space Peugeot gave them.
The loom is vehicle-specific, not a bundle of bare wires, and we'll match it to the connector your car carries, so if you've had someone in there with scissors, say so early: a cut harness turns an afternoon into a frustrating fortnight. Maddening, that one. Tell us what your car came with and we'll send the matching Peugeot 3008 2012 Factory Radio Replacement list in the same reply.
A slim column of touch keys runs down the left edge for power, home, back and volume, so the basics don't need a swipe at speed. On a Peugeot 3008 the panel stands clear of the console instead of sinking in, which puts the screen closer to your eyeline. Annoying little thing, and you notice it every morning.
It's a tile grid: navigation top left, music and radio beside it, phone along the bottom. What I see most on a 3008 is a phone on a cradle and a screen nobody's using. Here map, album art and call share one panel, which is what a Peugeot 3008 2013 10.1-inch Screen Upgrade should buy you. The trim below stays standard.
The kit ships as a screen plus dash kit fascia. The rear-view camera, 360 camera set, front DVR, DAB+ antenna, OBD reader and tyre pressure kit are separate parts we stock, not box contents: order them with your screen and they'll travel together, and if you fit a camera while the dash's open you save an afternoon.
There's also a 2K version of this screen, 2000x1200 on a fully laminated panel, and it's a different kit rather than a firmware option. Want the sharper panel? Ask and we'll quote that part. Voice control's available as an option on these platforms too. Neither changes the fascia or the Peugeot 3008 2009-2016 GPS Navigation System behaviour, and it's the same Peugeot 3008 2009-2016 Car Multimedia Player underneath either way.
Send a console photo and your VIN when you order, because two minutes of photography saves a return parcel and lets us confirm the fascia, the harness and whether the dash has been modified. We dispatch worldwide, with Europe, the Middle East, Australia and North America all routine here. Tell us what your Peugeot 3008 carries now and we'll send the exact parts list.
Full details for this Peugeot 3008 2012 Factory Radio Replacement kit are on the product page: See the 9430/2430 on the product page.
Zhuhai WITSON Industrial Co., Ltd. - Tel: +86-756-8120312, 8120211, 8120212.
Send your model year and a console photo, and we confirm the fascia before it ships.
Check the 9430/2430 for your 3008The kit covers the Peugeot 3008 2009-2016 in both layouts we photograph. Match the openings under your radio: three round ones, or two round plus a centre cutout. Either way you're looking at a Peugeot 3008 2009-2016 CarPlay Screen once it's in.
Yes. It's cut around that panel, and we'll keep the original climate control panel exactly where Peugeot put it, which is why this kit exists instead of a flat plate.
From the passenger seat, not much. The trim below the screen and around the gear lever is your own, and the fascia is moulded to the console shape. The screen standing above the dash is the visible change.
We ask for it. Two cars of the same year can leave the line with different connectors, and the VIN plus a photo settles the harness.
You can, but I'd fit it with the screen. The cable run is the tedious part, and doing it once beats opening the same trim twice on a Peugeot 3008 2013 10.1-inch Screen Upgrade.
Then send the console photo and let us check it against the fascia. We won't promise a fit we haven't seen, and that answer is free.
If you are an installer or wholesale partner interested in 9430/2430 bulk orders or custom fascia modification, reach out to our team for special terms and technical document package.
